Movie Villain Christmas Necktie

Hello everyone

I created a tie using Hueforge from images of movie villains, to which I added Santa hats using Photoshop.

The print colors are black-red-green-white from bottom to top.

If your printer profile settings are not applied:

I took my settings from this video: Bing Video, the settings information starts at approximately 5:10 minutes.

The tie consists of six plaques, five connectors (each with a front and back), and a hanger.

The plaques have corresponding slots (represented by negative parts in the print preview) to assemble them into a tie after printing using the connectors.

The connectors are labeled on the front; from top to bottom, the tie reads: “We wish you evil Christmas”

After assembling, you only need a piece of string; I used an unused shoelace.

I have worn my tie to two parties and would advise against gluing it to the holder.

Firstly, the holder (with the string/shoelace) is significantly easier to fasten around the neck if the tie is not attached. Secondly, you will hear the phrase “May I have a look at that” very often. I simply remove it from the holder and reattach it afterward.

Have fun with it.

Tim