HERO S02 Hand Crank Coffee Grinder Storage Case

HERO S02 hand-cranked coffee grinder storage box.

Required Accessories

Magnets: Six 5x5mm cylindrical magnets

Paper clips: Two

Precautions

1. When installing the magnets, pay attention to the magnetic polarity; otherwise, removal may be difficult.

2. If the purchased magnets are slightly mis-sized, use a small amount of adhesive. While most purchased magnets have a 5mm diameter, the height may vary. Exercise caution during installation; excessive force may compress the magnets, making them uneven with the box surface and thus detracting from its aesthetic appeal.

3. Use a straightened paperclip for the hinge connection.

4. Post-printing, the hinge holes may contain residue. Clear this using a paperclip.

------------------------------------------------------------------------------------------------------------------------

hero s02 hand-cranked coffee grinder storage box.

Required accessories

Magnets: 6 cylindrical 5*5mm

Paper clips: 2

Precautions

1. Pay attention to the magnetic direction when installing the magnet, otherwise it may be difficult to take it out after putting it in.

2. If the size of the purchased magnet is slightly deviated, you can use some glue. Generally, the diameter of the purchased magnet is enough for 5mm, but the height may not be 5mm. Be careful when installing it. If you use too much force, the magnet may be pressed too low and uneven with the box surface, affecting the appearance.

3. Use a straightened paper clip at the hinge connection

4. There may be some residue in the hinge hole after printing, which can be cleared with a paper clip.