Xtool S1 Power supply mount
Print Profile(1)
Description
An under desk mount for the Xtool S1 power supply.
The 2 pieces slide on from the sides and need to be pushed over the small feet of the power supply so that it can't fall out.
It attaches to the table with 3mm screws. (note, don't tighten the screws too hard so that the printed mount does not split)
The design has a 16mm gab from power supply to table to not trap heat of the power supply.
I printed the mount out of PLA, but PETG would be a better choice of material because it needs a bit of flex to get over the feet of the power supply.
Also Print with 4 layers wall thickness for optimal strength.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (26)