Don't Close Door - Alternate Door Stop

Screw on door stop. Keeps a door for latching. We use it for airflow, or to let the dogs go in and out of the garage freely without worrying about them getting locked in and out.

Should fit any door latch/bolt. Just loosen the 1 or 2 screws on your door jam and insert the block. Prints shown are in PETG, but would work fine printed in any rigid filament.

*Warning, if it is a door you care about, put a bumper on the print or the door to prevent damage when used over a long period of time.

The posted print profile is for the 3-inch version of this door stop. In the downloads on this page, there are both a 0-inch and 1-inch version step files if that is a better fit for what you need.