Crown Headwear

Crown Headwear

• An exquisite and regal crown headdress, which can be enlarged and worn as a crown (different print sizes can be offered as needed), or used as an ornament; it's also perfect for stall decoration.
• Optimized supports are pre-set in the initial configuration.
• A smaller version with an inner circle of 72mm is provided in the initial configuration due to the extended printing time upon enlargement. You can scale it according to your needs (Supports will change after enlargement, and you need to adjust them yourself, or leave a comment and I will help you with the slicing.)
• Default layer height is 0.20mm; 100% print speed is recommended.
• Pay attention to heat dissipation if the overhang quality is unsatisfactory! Also, calibrate the filament flow rate and dry the filament for better print quality!
• Welcome to share your prints, and feel free to leave comments in the comments section if you have any questions. Let's discuss and solve them together!

3D Printing Tips and Preparation Notes

(Most models published by creators have been tested and are compatible with all machine models. In many cases, printing problems should be checked if the printer and materials are working properly. This is a skill you need to learn in 3D printing. If you encounter any problems, please feel free to discuss them in the comments section. This is also the significance of building such a community.)

Some precautions are explained below. For more questions, please contact customer service or check Bambu Wiki. You can learn a lot there.Print Quality and Troubleshooting | Bambu Lab Wiki

• Ensure the build plate is clean, and clean it regularly! Oil residue from touching the build plate will significantly reduce adhesion, and debris or small residues from previous prints will also affect the quality of the first layer, thereby reducing the yield.
• Pay attention to filament drying, which will greatly affect your print quality and experience! Filaments that have been stored for a long time are prone to moisture. If stringing occurs, please ask the manufacturer for drying parameters to dry the filament. Meanwhile, most manufacturers do not dry the filament before leaving the factory, so newly opened filaments may still be slightly damp and are recommended to be dried before use.
• When using new filament from a manufacturer, it is recommended to start printing and calibrate the filament flow rate immediately, and modify the calibration factor. This will greatly affect your print quality and is a necessary process for adapting the new filament to your printer.
• If you encounter a sudden drop in print quality and a low yield, check if the nozzle is clogged, and you can also try recalibrating the printer.
• Print at the recommended speed in the model instructions. Overhang quality is directly related to print speed. An appropriate speed (too fast or too slow is not good) allows the material more time to cool and form during deposition.
• Set the heat bed and nozzle temperature appropriately according to the material. Excessive or insufficient temperature will lead to warping, layer deformation, or adhesion problems, thus affecting the print quality and success rate.