Quick-release PTFE tube holder for SKÅDIS

Version 2 is available! Much stronger and stable

— 

Features

• All parts are detachable so you don't need to insert the tubes by the ends
• Works with standard tubes, measuring ⌀ 4mm
• Prints with no support in ~30mins
• Weighs only 5 grams

Releasing the joints (first time only)

You will need some needle-nose pliers and do the following very gently.

Method 1

If you are lucky, on the first attempt, they will be detached already. You may need to do this on the two sides of the inner walls. Otherwise, try method 2 below.

Method 2

Squeeze the little joints connecting the Mount and the Cover. Again, do it very gently or they may break! See the picture below. As you do it, you should hear 4 click/pop sounds indicating they are getting detached. 

Once the cover is successfully released, the next time they will become a quick-release and snap-fit component! :) 

For long-term use and more durable print, I'd recommend using PETG. I noticed that with PLA, the component could come loose over time.