Two Layer Jewelry Organizer

UPDATE 02.01.25: Added the “lid.stp” file for easy box lid personalization, if needed.

My goal was to create a jewelry organizer that is both practical and stylish, with a clean design. I worked on it for a couple of months alongside other models, and it went through many iterations before reaching this final version. I’m very happy with the result. My daughter loves it, and that is the most important thing! :) I hope you like it too!

Features

• Limited lid opening angle keeps the lid upright and helps prevent the organizer from tipping over.
• Silent and smooth hinge movement.
• Top layer with compartments for rings, earrings, soft bracelets, and necklaces.
• Handle on the top layer for easy removal.
• Bottom layer with three compartments for larger jewelry.
• Magnetic lid closure.

Printing tips

• Make sure your bed is properly calibrated. A warped bed is the most likely cause of fitment issues when the top and bottom parts come together.
• Make sure your print plate is clean. This is a large model, and it may warp if adhesion is insufficient.
• The glossy lid effect was achieved using the Bambu 3D Effect Plate - Starry Surface.

Assembly

• Pay close attention to magnet polarity when inserting the magnets. A reversed magnet will be very difficult to remove without damaging the model.
• Refer to the picture below for hinge assembly.
• 

P.S. If you like my work please boost, like, rate or comment. This will help me to continue materializing my ideas in this new world for me. Happy printing! You can check my other models HERE.