HoHoHo Christmas Light up Sign

This is an assembly, that is printed in parts and then glued and snap fit together.

Parts List

• A strand of LED lights
• Micro rocker switch for the on off
• USB cord, or alternative cord for power
• CA Glue, hot glue
• RED, Green, White, Black, Gold PLA 

Steps

1. Print all the frames in black PLA
2. Print all the H inserts in the colors of your choice. I chose Red, Green and White. Note: the red and green inserts (H1 and H2) have a thinner face to allow more light transmission.
3. Print the O inserts - They have been colored already in the 3mf
4. Glue all the frames together using CA glue, and CA accelerator. I find putting them on a workbench and pressing them together helps alignment.
5. Run Leds through the inside, and I recommend taking spots with hot glue to ensure the LED strip does not come loose. I used natural white 5v leds
6. Install the Power Switch and wire up the LED's. I use these USB cords to power this as I used 5V LEDs, you can use 12V or whatever you like. Or you can skip lights altogether. You must cut off the micro USB end and solder the (+) and (-) to the less. 
7. Press fit the inserts into the frames. Be careful it is a tight fit and this is by design, just push them slowly and evenly.

Enjoy! Happy Holidays 🎅🎄