Search models, users, collections, and posts
Lift Table 130x100
IP Report
Print Profile(1)
0.2mm layer, 3 walls, 10% infill, brims and supports enabled where needed/suggested
8 h
4 plates
Open in Bambu Studio
Boost
729
1747
101
49
1.7 k
862
Released
Description
Summary
There are no details here except those that you can print yourself.
Supports should only be set when printing Base_gr and Base_top, the overhang angle of the support is 82 degrees, so that the support is not printed in the holes, otherwise they will be difficult to clean.
All the details are located in the files with the orientation as they should be printed. The required number of parts is multiplied for successful assembly.
The platform dimensions can be easily modified, increasing to 250 mm if necessary for your needs. During the test, the platform withstood 5 kg of cargo.
Print Settings
Rafts:
No
Supports:
No
Resolution:
0,2
Infill:
20
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (101)