2020 Profile Tabletop Fasteners
Print Profile(1)
Description
Suitable for securing tabletops to 2020 profiles; at least four are recommended, one per side.
Modifying the arrangement angle in my print settings is not recommended, as this provides relatively better strength. Removing the brim is also discouraged, especially for the A1 and A1 mini. Even with super glue, I was unable to successfully print on the A1 mini (at 8°C ambient temperature). Printing failed on the P1S without super glue (haven't tested with super glue). Adding a brim enabled successful printing on both the A1 mini and P1S.
M5 cylindrical head screws are recommended. The length connecting to the profile should be 8-12mm (I used 12mm with a spring washer and a regular washer; without washers, a maximum of 10mm). The length connecting to the tabletop depends on tabletop thickness; at least half the thickness plus 6mm is suggested (self-tapping screws are required).
As shown below, a single screw is sufficient for the tabletop connection, though three are recommended if possible.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (1)