Gridfinity Holder for Fluke T5 tester

Hi This is a block I designed to hold a Fluke T5-1000 tester laying flat in a toolbox drawer.  It has clearance to keep the leads wrapped up as designed.  It has a gridfinity footprint of 2x7 with the end trimmed off a little that just barely gets it onto the standard build plate.  It works out well in my toolbox because my grids have some space above them, but if not you will have a half filled square at one end.  I was going to upload it with full block, but it doesn't fit on the 256mm build plate that way.  Hope you find it useful.

Happy printing