Search models, users, collections, and posts
Nozzle stopper
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 25% infill
Designer
1.6 h
1 plate
A1 - 0.2mm layer, 2 walls, 15% infill
1.3 h
1 plate
Open in Bambu Studio
Boost
1410
5000
223
100
3.5 k
2.6 k
Released
Description
A cap for sealant tubes. Section view shown for clarity.
I used to use a long screw. I tried the “condoms” - they don't work for me. This should work the same as the long screw, as it protudes into the sealant tube.
I added a profile to print at 45°, as this will make the needle stronger. Cut off the supports when done.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (223)