Search models, users, collections, and posts
Airtag Holder for SmallRig Cage
IP Report
Print Profile(1)
0.16mm layer, 2 walls, 50% infill
Designer
37 min
1 plate
Open in Bambu Studio
Boost
28
63
8
0
66
38
Released
Bill of Materials
Bambu Filaments
Select all
Description
This is an AirTag holder designed for the FX3 SmallRig HawkLock cage!
Instructions:
To install just print and press into the hole for the battery door!
To remove use the small silver tool included with your SmallRig cage to open the battery hinge arm.
Then use the same tool to gently pry out the holder until you can pull it out with your fingers.
I've been using this on my FX3 for a few weeks and have not had any issues with damaging the camera body by prying it out.
I'm not too sure on how many SmallRig cages this will fit but I've tried it on the A6700 cage so I believe most Sony cameras that use the NP-FZ100 style batteries should work.
Does not work on a7ii
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (8)