HT-X3006 Speed Gun Barrel Connector
Print Profile(1)
Description
Recently obsessed with soft-air blasters, I purchased the HT-X3006 speed gun to measure muzzle velocity. I found it difficult to operate while holding the speed gun by hand. So I designed this small device. It can be quickly and stably mounted to a 16mm barrel; if you need other calibers, leave me a message, and I will make a separate version for you.
Installation is easy. Remove the screw from the speed gun's loading port side. Then install the connector and tighten the screw.
Printing requires no support and weighs only a few grams; it can be completed in about 20 minutes.
Boost Me (for free)
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (3)