Search models, users, collections, and posts
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
1.6 h
1 plate
Open in Bambu Studio
Boost
24
109
10
1
125
33
Released
Description
If you don't want to use wall brackets to secure your Kallax to the wall, but do have several model stacked, this bracket keeps them from sliding around.
Print instructions:
PLA/PETG is fine
0.2 layer height
6 walls
100% rectilinear infill
On my picture only half of the bracket is visible because I have the inserts for the doors already installed.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (10)