Gift Card Snap Card

I liked the idea of the Money Snap Card, but I wanted to make one for a Gift Card.

When the print pauses, just drop in your Gift Card and then resume print!

I left enough space to include a small folded receipt, as some people like to do that as proof the card has money added to it.

There are 4 different kinds on 4 plates.
One has “SNAP AWAY HERE,” “GIFT CARD," and a “?” on it.

One has “SNAP AWAY HERE” and “?” on it.
One has just “SNAP AWAY HERE.”
And the last ones are BLANK.
(There seems to be a glitch in Bambu Studio where the texts can sometimes move around on their own, so it might be a good idea to verify the texts are properly in their place before printing if you decide to use those versions.)

Recommended to print this in PLA.

Ignore the message about needing supports. It says that because I had to make the interior thicker for the gift card, which made the snap walls thicker, so I had to thin those out. And because those walls were thinned out where it snaps, it won't show up after being sliced unless you check off “DETECT THIN WALLS.” So, make sure that is on!
 

Enjoy!