Search models, users, collections, and posts
Ender 3 to Laser Cutter Conversion: Z-Axis Adjustment Knob
IP Report
Print Profile(1)
0.28mm layer, 5 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
20
31
6
1
73
18
Released
Description
I added a 20w Diode laser module to my Ender 3 - not as a addon, but to replace the 3d printing functrion entirely and just use it for it's XY axis's and control board! Read more here - https://hackaday.io/project/202092-old-3d-printer-to-laser-engraver-conversion
These parts attach to the Z axis lead screw to enable adjusting the focus of the laser module when attached. The knob SHOULD screw on to the lead screw and just hang on. I didnt need to use glue - your miliage may vary however! Make sure to un plug the Z axis stepper motor too!
Check out the build video!
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (6)