Search models, users, collections, and posts
Simple Clamp Print in place
IP Report
GIF
Print Profile(2)
Single Color
Designer
32 min
1 plate
0.2mm layer, 4 walls, 30% infill
Designer
1.9 h
1 plate
Open in Bambu Studio
Boost
119
269
32
10
332
216
Released
Description
A simple clamp for holding things together!
The design was made to work in PETG, so your mileage with PLA may vary. Generally I recommend printing with 3+ walls, 25%+ infill.
WARNING: Don't press the clamp while still warm from the printer! This will permanently lower the tension and prevent it from closing fully. Wait for it to cool down.
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (32)