10-Minute Quick Print Disposable Filter for Floor Drains or Washbasins
Print Profile(3)
Description
Update:
V2 20250114 Based on several days of use, a series of improvements have been made to V1:
1.Reduced infill from 45% to 30% to enhance water flow
2.Replaced the central cylinder with a hexagonal prism, with three sides hollowed out, to enhance water flow
V1 20250102 Base version
Design Overview:
A disposable filter for the bathroom sink was previously printed, but it was discovered that it was easily washed away when the faucet was turned on fully, so several improvements were implemented.
Scope of Application:
Suitable for unobstructed bathroom sinks (such as those that were originallypush-type sinks with the push spring removed), or typical floor drains.
Print Time:
Individual print time is 5 minutes and 58 seconds, with a total time of 11 minutes including preparation
Printing multiple units simultaneously is recommended; nine units require a total print time of 44 minutes (A1)
Weight, Filament, and Cost:
Standard PLA filament is suitable for printing; material consumption is approximately 2.5g.
Strength:
Should withstand normal use.
Source Files and Modifications:
STL files are available for adjusting the size; feel free to leave a comment or send a private message if you encounter any problems during use.
Your prints and feedback are welcome. The design will be iteratively updated based on your suggestions. Thank you.
Quick Print Series Collection:https://makerworld.com.cn/zh/models/640204#profileId-579710
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (4)