Search models, users, collections, and posts
Creality Space Pi Heat Shield / Heat Deflector
IP Report
Print Profile(2)
0.4 mm Nozzle, 0.2mm layer, 4 walls
Designer
43 min
1 plate
0.6mm nozzle, 0.24mm layer, 3 walls
Designer
1 h
1 plate
Open in Bambu Studio
Boost
1447
4104
508
151
4.9 k
2.6 k
Released
Description
Hey everyone,
i designed this filament protection shield to keep your filament safe. So it will not deform or melt when drying your filament.
You may ask why? I measured the the air temparature of the outtake. When for example i set the target temperature to 60 the meassured air temp of the outtake is sometime 75 degree hot. There are also discussions on reddit about that.
I don't print out of the dryer. If you do. This might be not necessary. This is for everyone who just put their roll of filament into the dryer.
Important Note:
Don't print the shield with materials which can not withstand higher temp. It will deform. Use ASA or ABS. More temp resistant materials should work as well. E.g. Dont use petg to dry petg.
Happy drying
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (508)