bixi

cover

plate_1.png

2025-01-05_6e9b20203aac9.png

0.2mm layer, 6 walls, 25% infill

ZipTie.png

x25 on 1 plate, 0.2mm layer, 6 walls, 25% infill

stlcardsfan88

IMG_8853.jpg

Printing from Makerworld only lets you do 10 qty of a time if the model is a single. I created a plate of 20 as I used alot of these.

PLATE of 20 0.2mm layer, 6 walls, 25% Gyroid infill 

for 20mm velcro straps

user_596871009

WhatsApp Image 2026-03-03 at 21.51.19.jpeg

WhatsApp Image 2026-03-03 at 21.51.18.jpeg

profile.png

I stretched the original model in the X direction 1.5x to fit 12mm velcro straps. You can also still pass zip ties in the other direction. Unfortunately this also stretches the screw hole, but it should work in a pinch. I use these with mounting tape. Print profile is 0.20mm with 6 wall loops.&nbsp;I modified it in the middle of an office makeover, so I did not modify the model beyond the scale in the X direction, so if you need these zip tie anchors to be absolutely perfect, this one might not be for you. These still feel very solid thanks to the robust original design and the 6 wall loops.&nbsp;A plate with 10 of them printed in 47mins on my P1S.&nbsp;If you have wider velcro straps, you can use the scale tool to stretch them further, but I would advise against it because at 1.5x you start to see some overhang failures.

stretched for 12mm velcro straps, 0.2mm layer, 6 walls

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.

This user content is licensed under a Standard Digital File License.

<boostme><boosttitle>Boost Me</boosttitle><boostcontent>If you liked my design, I&#39;d really appreciate your support ! Thanks</boostcontent></boostme>Mount / Holder for your Zip Tie (serflex).Use full for cable / wire management.&nbsp;Low profile: only takes 4.5mm heightLow weight: less than 1gr of filamentLow print time : 10 minutes&nbsp;2 mounting ways : double sided adhesive or screw (hole is 3mm diameter wide)&nbsp;Check my <a target="_blank" rel="noopener noreferrer ugc" href="https://www.patreon.com/Bixi3d">patreon </a>for supporting me or get a commercial licence to sell physical prints of my models.

Zip Tie Mount | Low Profile  (adhesive or screw)

ASIA

Print Profile(4)

Description

Comment & Rating (39)

License

Related Models