Kreg Track Saw Square V2

Kreg Track Saw Square V2:

This is V2 of the Kreg Track Saw Square. A user stated that the post for the cams broke on their model so I redesigned it to be stronger. The posts are now much larger in diameter. They are solid due to the number of wall loops. I also increased the infill ratio and redesigned it to no longer require any hardware. The whole thing can now be printed. I recommend using PLA+. 

Assembly:

1. Remove supports
2. Place cams on posts
3. Place washers on cams
4. Twist screws into cam post holes

Use:

1. Insert the hooked end at roughly 45 degree angle to the underside of the track with the cams turned sideways. 
2. Bring to level with track
3. Turn cams until snug and roughly equal to each other. (Cams do not to be fully perpendicular to the track. Turning them past snug puts undo stress on the cam posts.)
4. Use it.

Original V1 File Description:

This is a square for the Kreg Track Saw or “Adaptive Cutting System” to allow you to quickly square with sheet goods. It latches onto the track using cam locks. Ensure that the cams are turned to roughly the same position when installed on the track to make sure it's square. I printed mine out of PLA+ but regular PLA should work fine. This is my first upload. If you have suggestions for improvements, please leave a comment.

 

While not absolutely necessary, for best results you will need:

 

• 2 M5 threaded inserts
• 2 M5 washers
• 2 M5 button head or pan head screws