Search models, users, collections, and posts
Minimal EDC Key Holder
Remixed by
IP Report
Print Profile(3)
Minimal EDC Key Holder (Nut Version)
Designer
1 h
2 plates
Minimal EDC Key Holder (Threaded Inserts Version)
Designer
1 h
2 plates
0.16mm layer, 4 walls, 15% infill
31 min
1 plate
Open in Bambu Studio
Boost
92
219
24
6
220
149
Released
Bill of Materials
Maker's Supply Kits and Parts
Select all
Description
A sleek and minimal way to store and carry your keys.
This model was adapted from Fatlip's design, where I redesigned most of the parts to be easier to print and added a variation that uses M3 nuts instead of threaded inserts, as these are more readily available for most people. See below for the full list of changes.
Change Log
- Removed the fillet on the underside of the top and bottom housing to make printing easier
- Removed the need for screws when mounting the accent piece
- Added a fillet to one side of the threaded insert hole to allow for easier installation
- Improved some tolerances
- Added an M3 Nut version
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (24)