Wallet phone stand

This was a fun little project.  My objective was to create a functional phone stand that folds up neatly into my wallet.  What do you think?  It’s only 3mm thick and the precise dimensions of a credit card.  The stand supports my iPhone 16 Pro Max easily in landscape and portrait orientations.

No assembly required.  The hinges are print in place.  

Quick print.  No supports.  PLA Basic.

0.4mm nozzle.  0.2mm standard settings.

I recorded a short video demonstration, but can’t seem to figure out how to upload it.  If someone could explain how, I’ll gladly post it.   In its absence, regarding assembly: It’s fairly obvious how it unfolds.   The one thing I should point out is how to raise the center section.  Slide it out.  Rotate it by 180 degrees and reinsert it back into the same slot.  

I’d love to hear feedback.