PV module holder, different versions
Print Profile(1)
Description
Several versions of a PV module holder are available.
Photovoltaics
Be sure to print with a temperature-resistant material; the PV panels get very hot!!!
ABS or ASA minimum.
Please also pay attention to wind loads.
My recommendation: The pressure of these holders is sufficient for freestanding small PV systems, as seen in my photos.
Do not mount on roofs, carports, garages, houses, or similar.
The mounts should be printed with sufficient infill and a minimum of four wall lines.
I use ABS filament for this.
____________________________________________________________________________________________________________________________________________________
PV module holder, various versions
Photovoltaics
Please be sure to print with a temperature-resistant material. The PV panels get very hot!!!
ABS or ASA minimum.
Also, please pay attention to wind loads.
My recommendation: For freestanding small PV systems, the pressure of these holders is sufficient, as seen in my photos.
Do not mount on roofs, carports, garages, houses, or similar.
The mounts should be printed with sufficient infill and a minimum of four wall lines.
I use ABS filament for this.
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (3)