Search models, users, collections, and posts
DN50 Vacuum Valve Cyclone Separator
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
Designer
57 min
1 plate
0.2mm layer, 2 walls, 15% infill
1.5 h
1 plate
Open in Bambu Studio
Boost
36
130
9
4
111
56
Released
Description
Content has been automatically translated.
I created a print profile and used 3 threaded nuts m4
Original by ronny130286
Thingiverse text:
Because my vacuum cleaner always pulled my cyclone bin together, I designed and printed a DN50 vacuum valve.
I installed the valve in front of the cyclone separator towards the clean side via a T-piece.
The tension of the spring can be adjusted with the M5 screw.
The M5 nut will be pressed directly into the valve body.
The valve can be inserted directly into the T-piece.
Additionally required:
3x M4x10mm screws
1x M5 screw => length may vary
1x spring
2x U washers for M5
1x self-locking M5 nut
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
Comment & Rating (9)