Search models, users, collections, and posts
iPhone 13 mini Bumper Case
IP Report
Print Profile(2)
0.16mm layer, increased length for shrinkage compensation
Designer
42 min
1 plate
0.16mm layer, solid, 100% infill
Designer
42 min
1 plate
Open in Bambu Studio
Boost
54
136
20
2
266
197
Released
Description
Really wanted a bumper case that exposes the back glass of the phone and side/bottom edges for easier screen gestures. But I wasn't able to find one. At least for 13 mini. So I make one myself.
Recommendations:
- It's preferable to print on a smooth plate.
- Check your dimensions. For me, it was required to add 0.5 percent to the length and set X-Y hole compensation to 0.2mm.
I also share raw Fusion 360 model where you can configure basically everything. Maybe even adapt it to other iPhones.
See my other models:
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (20)