Search models, users, collections, and posts
Tripod Phone Stand
IP Report
Print Profile(2)
0.16mm layer, 2 walls, 15% infill
Designer
4.8 h
1 plate
0.16mm layer, 2 walls, 15% infill
4.2 h
1 plate
Open in Bambu Studio
Boost
233
471
44
12
727
353
Released
Description
Neat little tripod for your mobile telephonic device!
Pretty simple to print, minimal supports/brims.
Tested with PLA, does fit and screw perfectly fine but could be recommended to print the screws (or all) with PETG as overtighening could break them.
License
This user content is licensed under a Standard Digital File License.
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (44)