Search models, users, collections, and posts
Air assist Laser (Used on Atomstack S10 PRO)
IP Report
Print Profile(1)
0.28mm layer, 2 walls, 15% infill
Designer
22 min
1 plate
Open in Bambu Studio
Boost
4
5
1
0
10
4
Released
Description
Turning my laser cutter into a jet engine, one puff of air at a time. Because who needs smoke and messy edges when you can blast it all away with science! Warning: May induce uncontrollable admiration from fellow makers and a slight obsession with airflow dynamics.
License
This user content is licensed under a
Creative Commons Attribution-Share Alike
Comment & Rating (1)