Claw of Scratching +1
Claw of Scratching +1
Boost
103
147
18
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
19 min
1 plate
Boost
103
147
18
1
108
169
Released
Description
For when you need to scratch but have bad nails... Like my wife. Now she can't justify the super expensive manicures anymore!
After printing remove the little built-in support between the prongs and file the claw tip a bit if there are any sharp final layer artifacts.
Comment & Rating (18)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
cool
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great back scratchers!
1
Reply
my sister loves them
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed well. I upsized it 25% as the original is for small fingers. If you are going to print for bigger hands you will need to scale it up. Also don't forget to scale up one bigger than the others to fit your thumbs. Also may need to keep one smaller for your pinky.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
great file. but these were sized for very small fingers im going to try upscaling them a bit. my wife is excited to have her back scratched now.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
quite small though
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Easily the best back scratcher I own.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld