Here's a new model for the Pokemon suspended collection..

By request from some of my followers.. i made the original Pokemon GO egg incubator..

The model is made for multicolor prints.. I used the bambu LED kit 001 for the lights..

there is actually position for 2 LED kit lights both on the top and bottom.. but since i only have one kit.. i opt to put it on the bottom this time..

The top part of the incubator has a dummy/support that needs to be remove so you can insert the color screen..

To assemble the suspended egg is going to take a little patience:

1. If you are going to install the LED kit like mine.. you'll first need to insert the peg into the egg to help stabilize each half of the model
2. now there will be a channel in the back side of the frame holding the suspende model.. this is for the USB cable of the LED kit..
3. insert the cable and carefully close the 2 half.. you should leave some slack on the top
4. now use double sided tape on the LED kit and tape it to the top incubator.. there should be a channel for the wires too..
5. if you want to defuse the bright light you can use the screener i provided.. there should be grooves to insert the it..
6. now slowly cap the 2 half of the suspended egg
7. once close.. you can cap the bottom holder of the suspended model.. there should also be a channel for the USB cable
8. lastly the place it on the bottom piece of the incubator and there is also a slot if you want to put another LED kit for the bottom..

and you done..

If you're thinking of buying the LED kit.. please do support me by using my affliate link here.. LED LAMP KIT 001 every little things helps me out..

One important thing to remember when printing suspended model is to set the wall generator to arachne from classic.. this will make the slicer print the strings.. and NO SUPPORTS..

I hope you guys have fun printing the suspended pokemon go egg incubator..