Manga/Book Riser for IKEA Billy
Copyright Claim
Manga/Book Riser for IKEA Billy
Boost
82
172
18
Print Profile(2)
0.2mm layer, 3 walls, 10% infill
Designer
2.8 h
1 plate
0.2mm layer, 3 walls, 10% infill
5.5 h
1 plate
Boost
82
172
18
0
167
211
Released
Description
If you ran out of shleve space you have to go in two rows.
This riser gives you the possibility to rise the second line and add a little space below the books.
Comment & Rating (18)
All
Print Profile
0.2mm layer, 3 walls, 10% infill
Print with PLA basic Overture, nice and super useful. Thanks!
1
Reply
The climb? Is that in English?
0
Reply
Replying to @mitchg
The title is in english like the original but all the volumes are in italian :)
(Edited)1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
perfekter druck und super Qualität sehr gut
1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Not only is this a great model, but it is useful for many other projects that it wasn’t initially indented for. I printed one and then my wife and daughter wanted a few more each!
1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
These print nicely on the A1 mini and effectively increase the Billy shelf utility.
1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Had to put the Heat Up on the extruder an Bed ist was komisch of t the Coners.
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld