This is a new version of the Suspended raptor incubator i did a few months back..

i've been getting request to make the light comes from both top and bottom.. and i must say that it looks better with 2 lights..

Just like my pokemon incubator.. i ran the top LED kit wire on the side panel holder of the raptor.. i also added a thin layer defuser on the top and bottom grill to disperse the lights.. the bounced light also lit up the top cylinder panels and the bottom square panels..

The raptor 3d model is owned by wofle from turbosquid.com.. and he gave me permission to share my remixed version of the raptor as long i dont sell it commercially.. so thank you Mr Wolfe for sponsoring your awesome raptor model for my suspended models..

If you're printing this multicolor.. i recommend printing some of the incubator parts with transparent or white filament like i did for the top and bottom base.. so that the LED would shine through it and make it more cool..

Assembly is fairly simple.. you just need to be careful when adding the square peg into the raptor's body.. it should fit loosely.. the peg is just used to hold the 2 half of the raptor aligned.. the bottom parts should fit tight.. and the top slightly loose.. the base where you insert the LED kit should fit loosely to the middle base.. so that you can turn your raptor to whichever position you'd like without the wires in the way..

If you're thinking of buying the LED kit.. please do support me by using my affliate link here.. LED LAMP KIT 001 every little things helps me out..