Woodpecker toothpick box 啄木鸟牙签盒
Copyright Claim
Woodpecker toothpick box 啄木鸟牙签盒
Boost
234
311
17
GIF
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.7 h
2 plates
Boost
234
311
17
11
344
140
Released
Description
Woodpecker toothpick box
need a rubber band
Installation legend：
Comment & Rating (17)
All
it works great thanks man
nice model
1
Reply
All parts very tight to fit, very secure and nice model, thanks
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Does not fit together well and difficult instructions. Cool idea though.
The designer has replied
1
Reply
Different consumables have different shrinkage rates, and hole compensation can be adjusted according to the performance of the consumables used
(Edited)1
Reply
Could modify it to be a Q-tip woodpecker ? Thank you!
(Edited)The designer has replied
0
Reply
Cotton swabs are difficult to roll down due to the high friction of cotton
0
Reply
Thanks buddy!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
lid with the bird needs to have a way to secure it down it pops up when i use it
The designer has replied
0
Reply
Perhaps your material shrinkage rate is too high. Normally, the size is tightly matched and will not loosen. You can use glue to fix it
0
Reply
很有创意的作品
1
Reply
Boosted
thank you
0
Reply
very neat idea
0
Reply
STL檔
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld