Scandinavian Style Watering Can
Scandinavian Style Watering Can
Boost
143
219
18
Print Profile(1)
No supports, 0.16mm layer, 3 walls, 15% infill
Designer
4.6 h
1 plate
Boost
143
219
18
9
132
104
Released
Description
Scandinavian Style Watering Can
This is a modern, stylish and minimalistic watering can, inspired by some of the comercially available scandinavian designs.
Printing:
- Your printer needs to be tuned to handle a 45 degree overhang without issues!
- Print upside down, so that the spout rests in the print bed.
- 0.16mm layer height recommended for better overhangs.
- 15mm outer brim highly recommended.
- 3 Wall loops
- Top and Bottom shell thickness set to 2mm
- Paint seams like this to improve the overhangs on the spout:
- Supports are not necessary if you have bridging well tuned, but you could paint some on the underside of the handle:
Comment & Rating (18)
All
Print Profile
No supports, 0.16mm layer, 3 walls, 15% infill
a little leaky on the handle, but superglue does the Job.
0
Reply
Boosted
Print Profile
No supports, 0.16mm layer, 3 walls, 15% infill
(Edited)
The designer has replied
0
Reply
Thanks a lot for your make and rating! If you enjoy the model, please consider boosting it ^^
0
Reply
Boosted
Cooles Design
The designer has replied
1
Reply
Thanks a lot for your rating! If you enjoy the model, please consider boosting it ^^
0
Reply
Print Profile
No supports, 0.16mm layer, 3 walls, 15% infill
Nice design
The designer has replied
1
Reply
Thank you!
0
Reply
Boosted
Print Profile
No supports, 0.16mm layer, 3 walls, 15% infill
nice
The designer has replied
0
Reply
Thanks a lot for your rating and boost!!
0
Reply
Print Profile
No supports, 0.16mm layer, 3 walls, 15% infill
Works surprisingly well! Better than other watering cans I've printed
0
Reply
Print Profile
No supports, 0.16mm layer, 3 walls, 15% infill
Leider sickert immer durch. Nacharbeitung nötig.
0
Reply
Print Profile
No supports, 0.16mm layer, 3 walls, 15% infill
1
Reply
Print Profile
No supports, 0.16mm layer, 3 walls, 15% infill
1
Reply
Print Profile
No supports, 0.16mm layer, 3 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld