Glock 19 Gen 5 v3 with slide by RTX_Nitrox

RTX_Nitrox

Props & Cosplays>Replica Weapon

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

0.16mm layer, 2 walls, 16% infill

Designer

8.8 h

4 plates

4.9(9)

0.16mm layer, 2 walls, 16% infill

Designer

9.9 h

4 plates

4.6(9)

Boost

339

440

454

208

Released

Description

Discover the craftsmanship of our 3D-printed Glock 19 replica, an ideal accessory for enthusiasts, collectors, or anyone seeking a realistic firearm alternative for everyday use.

Check out my other models

Comment & Rating (47)

@untiedlaces

💀 in a Mother’s Day contest is wild

The designer has replied

@RTX_Nitrox

Why best present ever 😂

@untiedlaces

Replying to @RTX_Nitrox :

XD I think this is much more fitting for Father’s Day 💀

@WallyK24

Replying to @untiedlaces :

Moms like guns too

@levo3456

Print Profile

0.16mm layer, 2 walls, 16% infill

pretty good profile that works fine without a hassle

@onlinetransac

On your last design (Glock 19 V2) I could not get the slide to jolt back after it was cocked. The tollerences were too tight for the rubberbands to pull it back. Do you know if the tolerences are better on this one? Do you recommend specific print settings? I also noticed the corners on the Glock 19 v2 lifted a bit. Would you recommend me adding a brim on this one if that happens here? I know this is a lot but I couldn't get the mag lock to move also. It was stuck in the slot and any attempted of freeing it, broke it. Thank you!

(Edited)

The designer has replied

@RTX_Nitrox

If you use pla the tolerences should fit and I didn‘t use a brim

@user_1057487808

Print Profile

0.16mm layer, 2 walls, 16% infill

@FLGKstudio

Print Profile

0.16mm layer, 2 walls, 16% infill

@pccyrfndxx

so are the two pins irrelevant now? assuming that’s what was replaced by the two tabs

The designer has replied

@RTX_Nitrox

Yes

@user_408540850

Replying to @RTX_Nitrox :

Which tabs do you use instead of the pins?

@RTX_Nitrox

Replying to @user_408540850 :

The two smal Squares

@mattnixon360

It would be nice if the model had some texture on the grip handle

The designer has replied

@RTX_Nitrox

There is a Version 4 coming soon with a moveble Trigger and grip handle

@user_1078159190

For V4 can you standardize the wedge pieces that hold the 2 halves together? seems like some of them were randomly different sizes/widths and didn’t know which slot to put them in. Tried to put it together the first time and something was definitely mixed up and broke a few pieces. Otherwise this is an awesome model

@user_1134480086

Where do the rubber bands go

The designer has replied

@RTX_Nitrox

There should be a pin on both sides