Octopus Sculpture + Smartphone mount by MakerVerse Designs

MakerVerse Designs

Art>Sculptures

In Contest

Animal Frenzy

Print Profile(5)

All

P1S

P1P

X1 Carbon

X1E

Creality Ender-3 S1

A1 mini

0.2mm layer, 2 walls, 6% infill

Designer

4.5 h

1 plate

4.9(24)

0.2mm layer, 2 walls, 6% infill

Designer

13.1 h

1 plate

5.0(2)

More support, Gyroid infill, 0.2mm layer,

6.4 h

1 plate

4.9(11)

Minimum support OctopusHandy,0.2mmLayer,2,15% infill-A1 mini

5.2 h

1 plate

4.0(1)

Click to see more

Boost

411

625

604

319

Released

Description

A octopus sculpture which can hold any smartphone, tablet, etc or used just for decoration

needs to print with supports (I used Tree support, threshold angle set to 20°)

Have fun with it and leave a like or subscribe if you like it!

If there are any suggestions for improvement, feel free to write a comment.

Comment & Rating (48)

@toto_extreme

This looks amazing! I printed in Polylite PLA, and used tree supports -- Be sure to use "Support for PLA" if you have some, for the areas that interface with the model. Printed on Bambu P1S. Cheers.

(Edited)

@asecret

Good print, had zero issues on X1-C with PETG Basic... fuzzy skin 'contours'

@tdulny

Print Profile

Minimum support OctopusHandy,0.2mmLayer,2,15% infill-A1 mini

it's Okey but you should change little supports to safe print :) good model , nice look. have a nice day !

@quadbears

Print Profile

More support, Gyroid infill, 0.2mm layer,

not...terrible. the supports on the bottom didn't want to come off. and the bottom looked a bit rough even when it was supported

@bill.m.davis

This was a fun design. I am trying it out for a decoration for a children's under the sea event. If the decorators like it, I might be printing more. The only problem I had with it was one of the arms cracked when trying to remove the supports. So, if I print it again, I may attempt to make it stronger.