HellDivers 2 Hero of the Federation Cosplay Helmet
Copyright Claim
HellDivers 2 Hero of the Federation Cosplay Helmet
Boost
152
196
5
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
46.3 h
5 plates
Boost
152
196
5
0
209
10
Released
Description
You will have to order a gold tinted face shield, and cut it to size to compelete this
PLEASE ENABLE SUPPORTS, COULD NOT UPLOAD IT WITH ALL THE SUPPORT PROCESSING TIME
Comment & Rating (5)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
didn't print
The designer has replied
0
Reply
What went wrong?
0
Reply
Well
1
Reply
is there a good way to resize for head size?
The designer has replied
0
Reply
Just changing the scale of the print, but the one piece basically already takes up majority of the bed space , so you may have to use the " slice " option in BBLS to cut it into 2 pieces if going any bigger, smaller no problems though. just make sure you scale everything to the same amount!
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld