Update 1 (May 8 2024):
- Added new lid "Lid - with design (no AMS version)" to the print profile.
There are two different ways to print this, I described it below in the lid section. I also uploaded a reference photo.- Slightly tweaked geometry in the lid's hotend design - the top part where filament enters is now separated from the below body.
This is my first try at 3D modeling after learning in Fusion a little, I appreciate any feedback, and thanks for printing!
I recently bought the A1 Series Hotends Kit from Bambu Store and wanted myself a case that would fit everything
The case includes the following slots:
No supports are needed in any of the parts.
The model is optimized for printing with 0.4mm nozzle and 0.2mm layer height.
I measured the hotends and silicone socks to be tight fit in the slots so they don't move, but still not difficult to remove and insert
The lid comes in 3 versions: