You know, for christmas I like it simple. A simple tree, simple LED lights and some simple decoration. So I made a simple print-in-place christmas bell with clapper for you all to enjoy.
And for those who just want a bell without christmas decor, I also added an even simpler bell. Then you can put your own text and decoration on it. This is very easy in Bambu Studio.
Print the bell with 3 walls, 7 tops and 5 bottoms. Use 8% gyroid infill and no support. To optimize adhesion you should activate a brim and set it to 10mm. Z-hop should be at 0.8mm, this helps to print the small clapper. Print the model slowly - it is christmas, no need to hurry. I reduced alls speeds but first layer by 80mm/s.
The settings were successfully tested with Sunlu Meta PLA, Eryone Silk PLA, Redline Glitter PLA, Voxel PLA and Warhorse PLA. See my 3mf for more details.
The bell has a bottom diameter of 70mm and is 58mm tall. If needed the model can be scaled-up.
Disclaimer:
This work by blecheimer is licensed under CC BY-NC-SA 4.0
You are not allowed to copy this model to other 3D printing websites without my permission.