Simple Jug Can Pot Kännchen whatever to precisely

I designed these to mix up some epoxy for my knives and pour that precisely into the handle molds. But it works super good with water too!

I have 2 Designs: One with a handle to hold it with your fingers and one without if you have big hands like me ,-)

Antidrip Technology: The spout is designed so you can pour the liquid without spilling it all around and have it running down after using the jug.

Curved top: I designed the Top so it is slightly curved inwards so eventually upcoming splash might get catched during mixing.

Precise pour:

I initially designed this Jug to percisely pour mixed epoxy into smaller holes so they don't trap air inside and I dont touch the clean blades (added later in the process).

Robust & Waterproof

This Vase is printed quite fast since it has only 1 layer in Vasemode but still it can be very tough and waterproof!

Vasemode.

You can get very clean jugs if you print them with the Vasemode settings! But make sure that your temperature is dialed in correct! Else the Jug might not be waterproof and strong enough.

Nozzle SIze: The bigger your nozzle the stronger the Pot! But you can get more out of your standard ,4 mm Nozzle! Simply set the extrusion width to ,65 mm in your slicer!

Material
I used PETG for my Jugs since it is a little tougher and has a nice layer adhesion. But PLA worked good too. (Green one in my pictures)

Scalability.

Of course you can scale this design up/ down to match your requirements. But keep in mind that a bigger Jug will get to its limits if you fill it with heavy water and still print it with a ,4 mm Nozzle ,-)

Have fun!